K-Frame Cocker

Deadmeat99 · #1 06-30-2010, 02:15 AM

Got the frame from Dan the other day.

It has the rounded top for a Sheridan so I would need to flat to match the autococker body. Also thinking of something that threads into the back like the ivg but still allows for a normal length spring to be used and hold the frame. I will try and get pictures.

KPCS · #2 06-30-2010, 07:36 PM

Interesting ...... You want a K-frame on a Autococker ???? Very interesting ....

Doesn't the back of the K-frame have a velocity adjuster on it ??

Yeah I would like to help you make this happen.

Ken W

Deadmeat99 · #3 07-01-2010, 03:05 PM

Well I talked to you a little bit about it at SPE. So I am trying to get this done before next SPE. Mostly need the top of the frame milled flat instead of rounded like it is currently, and some sort of new velovity adjusted made.

I was thinking of cutting off the back of the body and making some sort of new velocity adjuster housing that threaded into the back of the body and was still able to use the mounting hole in the top of the k-frame and still alowed the use of standard length springs.

KPCS · #4 07-03-2010, 05:52 PM

Are you running this as a Pump or semi ????

Don't cut anything just yet.

Ken W

Deadmeat99 · #5 07-06-2010, 12:46 AM

Quote:

Originally Posted by KPCS

Are you running this as a Pump or semi ????

Don't cut anything just yet.

Ken W

Running as a pump, havent cut anything just been sanding a little. I will most likely be trying to put an karni pump front block on it and just running the tank off that. Should have more of the parts tomorrow so I will try to take another picture then.

Deadmeat99 · #6 07-09-2010, 05:34 AM

I was thinking of the pump handle coming back over the asa a bit, but unsure how much or how that will be possible.